temperature of combustion

Temperature distribution of combustion flame of double base propellant, composite propellant and NEPE propellant ( taking HNIW or HMX as oxidizer) were measured by using relative light intensity method.

采用相对光强度法测定了双基推进剂、复合推进剂及NEPE（氧化剂为HNIW或HMX）推进剂的燃烧火焰温度分布。

The temperature control of combustion furnace in Claus process

克劳斯法制硫工艺中燃烧反应炉的温度调控

Experimental study on mechanism of lowering ignition temperature of anthracite combustion catalyzed by Fe_2O_3

Fe2O3催化无烟煤燃烧燃点降低机理的实验研究

In this paper it is focused on the process of dehydrogenation of propane coupled with selective oxidation of hydrogen, especially on the technology of high temperature hydrogen combustion and SHC catalysts.

本课题以丙烷脱氢制丙烯-氢选择性氧化这一耦合新工艺为研究背景，重点研究其中的高温氢选择性氧化工艺及其催化剂的制备与性能。

The reconstruction and temperature control of combustion chamber of directed fired dryer

烘干机燃烧室的改造及温度监控

Temperature test of motor combustion gas flow field with thermographic instrument

用热像仪测试发动机燃气流场温度

This article introduced the computer measuring methods of temperature on internal combustion engin platform.

本文介绍了内燃机台架上温度的多种微机化的测量方法。

Controlling temperature of combustion furnace at 1 100-1 350 ℃ for protecting equipment from burning-down without lowering sulphur recovery;

控制燃烧炉内温度在1100-1350℃，既保证有较高的硫回收率，又不会对设备造成危害；

The reasons and eliminating method of coolant temperature unconventionality of internal combustion engine

内燃机冷却液温度异常的原因及处理

The wall temperature of combustion chamber is closely related to the work process of the engine. The wall thermal conductivity is unsteady in the short woring process of the combustor.

燃烧室壁面温度的变化和发动机的工作过程紧密相关，在短时间工作过程中，壁面导热处于非稳态状况。

The kaolinite may clag the ignition of coal, when the amount of kaolinite ratio is in 50%-60%, the kindling temperature is about 9 ℃-13 ℃ higher than single coal, and the stability of combustion decreases.

煤样的着火点逐渐升高，当高岭石的添加量在50%～60%之间时，着火温度约升高9℃～13℃，燃烧稳定性也降低；

Firstly, according to the thermodynamics laws, the adiabatic temperature of the combustion reaction was calculated to prove the possibility of the reaction.

首先，根据热力学定律，通过计算反应过程中的绝热温度，证明了反应的可行性。

For futher improving thermal efficiency, the temperature of combustion chamber will be further raised, and the materials of combustion chamber and gas turbine will be improved.

为进一步提高热效率，燃烧室温度将进一步提高，并对燃烧室和燃气轮机的材料进行改进。

A major challenge scramjet engines currently faced is the high aerodynamic heat load. The wall temperature of combustion chamber without cooling can reach 3000K, which exceeds the limit of the general material used.

超燃冲压发动机目前面临的一大难题就是极高的气动力热载荷，燃烧室壁面温度在未经冷却的情况下能达到3000K。这超过了一般结构材料的使用极限。

Ionization Effect in Flame and Temperature Measurement of Combustion Process in the Internal Combustion Engine

火焰的电离效应与内燃机燃烧过程的温度测量

Taking optimization of a real thermal process into account, the intermittent calefaction mode is superior to the continuous. Adopting high temperature of combustion air and relative large excess air ratio is an appropriate combustion mode which is reasonable and economical relatively.

从热工制度优化角度，保温炉采用间歇式的大火加热方式比连续式的慢火加热效果要好；采用较高的助燃空气温度的和较大的空气过剩系数是比较合理和经济的燃烧方式。

The pan temperature of swirl combustion chamber is highest. This paper describes several relative parameters for that part temperature, and proposes a quick cyclical experimental method.

柴油机中涡流燃烧室的镶块温度最高，本文讨论了影响其温度的诸参数，并提出快速周期试验法。

The reconstruction method, namely changing layer coal combustion for pulverized coal injection combustion, and temperature control of combustion chamber of directed fired dryer are introduced.

介绍对烘干机燃烧室的改造方法，即改层煤燃烧为喷煤粉燃烧，并对温度实施控制。

Calculating of the Theoretical Temperature of Combustion of Blowing Tuyere in the Co-injection of Natural Gas with Pure Oxygen BF Process

全氧喷吹高氢燃气高炉风口理论燃烧温度的模拟计算

The lower the oxygen concentration, the higher will be the temperature of the combustion assisting air, which is needed for achieving a stable combustion.

含氧浓度越低，稳定燃烧所需助燃气流温度也越高。

Adopting high temperature of combustion air and relative large excess air ratio is an appropriate combustion mode for the furnace.

采用高温助燃空气和较大的过剩空气系数是一种较好的燃烧方式。

Single pulse BOXCARS applied to measure temperature of transient combustion

单脉冲BOXCARS技术在瞬态燃烧场测温中的应用

An Investigation on Radiation-Intensity-Based Temperature Measurement of Combustion Process& Theory, its Digital Emulation and Experiment

燃烧过程光辐射度测温研究&理论、数值仿真和试验

Real Time Diagnostics of Instantaneous Temperature of Combustion and Explosion Process by Modern Spectroscopy

现代光谱对燃烧与爆炸过程瞬态温度的实时诊断技术

Flame temperature of gas combustion reaction

煤气燃烧反应的火焰温度

The results of batch feeding experiment showed: the temperature of primary combustion chamber was influenced seriously by the preheating temperature and the feeding quantity.

批次投料实验结果表明：一燃室预热温度与给料量均对炉内温度变化有影响。

Study shows that particle diameter, oxygen and temperature of combustion environment play an important role on burnout or time for burnout of coal.

研究表明，煤粉颗粒的尺寸大小、燃烧环境中的氧量及环境温度对煤粉的燃尽或燃尽时间有很大的影响。

Measurement of temperature in a combustion field by BOXCARS

BOXCARS测量燃烧场的温度

The result shows that this three-dimensional arithmetic model can reflect the law of the flow field and temperature distribution of combustion space more completely.

结果表明，该三维数学模型能够比较全面地反映火焰空间速度场、温度场分布的规律；

A monitoring method based on visualized three dimensional temperature field of combustion in the furnace has been presented.

介绍了一种基于炉内燃烧三维温度场可视化的监测方案。